4/3/2023 0 Comments Macminer low hashrateThe value -1 disables the booster for the specific card (or whole system if only one value is passed). It’s possible for overclocking to cause hashrate abnormalities without the presence of high reject rates and other anomalies. Excessive overclocking: Excessive overclocking will lead to a big loss on hashrate. Devfee setting on mining software: 0.5 to 2 of the hashrate will be deducted and converted into developer fees. You can press the pencil icon next to the launch options listed under coin, pool and wallet selection menus and then manually add -lhr X, where X is a number between 0 and 100 to adjust the value, including on per-card basis, separating the values via comma: -lhr 70.1,0,68.5,-1. Network latency: Network latency will cause a small percentage of hashrate loss due to a failure of submitting hashrate from the miner to the mining pool. The expected results with options -lhr-mode 1 -lhr 74 set are about as following, when including manual overclocking: In Simple configuration mode, choose the coin, pool and wallet that you want to use.īy default, the miner automatically applies the parameter -lhr 74 for Ethash-based mining and mode 1 set.Scroll down to the "Default miner" entry and select NBMiner.Open the Worker's config by going to the workers list and clicking the wrench icon next to the worker you want to configure.In the below example we'll be setting up booster for ETHW mining with default options, you can change the advanced config further with the values mentioned above, how to change them is explained below, at the end of this section. computer moreover, macminer provides support for 3 major mining backends. With GDDR6 memory chips from other vendors (Micron, Samsung), the suggested starting value is -lhr 85 Lower voltage will yield a lower power dissipation but will be unstable for.SK Hynix-made GDDR6 chips don't behave well with the unlock, and the performance is poor, so it's not recommended to use the unlock on them.However, it is only being reported on windows at the moment, since Nvidia currently doesn't provide a public access point in the Linux drivers with that information, so you would need to judge by results or try to find out based on serial/part number of the cards, or, by disassembly of the cards to see the brand logo on the memory chips themselves, which is the most reliable but most time consuming method.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |